The information in this article applies to :
OroTimesheet 5.x (English)
OroTimesheet 5.x (French)
Description
This problem can occur when you install OroTimesheet in a folder, then later, you reinstall OroTimesheet in a different folder. In such case, it can happen that OroTimesheet is not able to find the file midas.dll anymore since this file was registered as being located in the old installation folder of OroTimesheet.
Solution
To correct it, you must manually register the file midas.dll again using the following instructions:
1- Open an MS-DOS session.
2- Go to the new OroTimesheet installation folder (for example: C:\Program Files\OroLogic\OroTimesheet5) using the following commands:
C:
CD "\Program Files\OroLogic\OroTimesheet5"
3- Then, enter the following command to register the file midas.dll again:
REGSVR32.EXE MIDAS.DLL
4- Then, enter the follwing command to quit the MS-DOS session:
EXIT
5- Run back OroTimesheet and your reports should now work fine.
Status
Note that starting from version 5.23, this problem was fixed in the OroTimesheet installation program .
|